Determination of Dehumidification Capacity of Water Wall with Controlled Water Temperature: Experimental Verification under Laboratory Conditions

journal article in Web of Science

English

Water elements with flowing water on the surface are common in buildings as a form of indoor decoration, and they are most often perceived as passive humidifiers. However, by controlling water temperature, they can be also used for air dehumidification. The dehumidification capacity of indoor water elements was investigated experimentally under laboratory conditions. For the experimental verification of dehumidification capacity, a water wall prototype with an effective area of falling water film of 1 m(2) and a measuring system were designed and developed. A total of 15 measurements were carried out with air temperatures ranging from 22.1 degrees C to 32.5 degrees C and relative humidity from 58.9% to 85.6%. The observed dehumidification capacity varied in the range of 21.99-315.36 g/h for the tested measurements. The results show that the condensation rate is a dynamic process, and the dehumidification capacity of a water wall strongly depends on indoor air parameters (air humidity and temperature). To determine the dehumidification capacity of a water wall for any boundary conditions, the equations were determined based on measured data, and two methods were used: the linear dependence between humidity ratio and condensation rate, and nonlinear surface fitting based on the dependence between the condensation rate, air temperature, and relative humidity.

water wall; falling water film; relative humidity; temperature; condensation rate; dehumidification

ČÁKYOVÁ, K.; VRANAY, F.; VERTAL', M.; VRANAYOVÁ, Z.

19. 5. 2021

MDPI

BASEL

2071-1050

Sustainability

13

10

Swiss Confederation

1

17

17

https://www.mdpi.com/2071-1050/13/10/5684

http://hdl.handle.net/11012/200875